Cartridge anchoring fischer - ml.300 t-bond - p/gun silicone

The resin hybrid for anchors in concrete cracked and masonry, in cartridge format silicone

T-BOND PRO.1 is an adhesion layer chemical certified for use in concrete cracked and non-cracked and masonry.

The resin injection can be used in the holes, wet and wet water.

The Portland cement content in the adhesion layer chemical T-BOND PRO.1 allows you to maintain high levels of load for the temperature range of - 40 °C up to +120 °C.

The wide range of accessories available for the resin T-BOND PRO.1 ensures the great flexibility of the system and allows for a wide range of applications.

T-BOND PRO.1 can be used with the standard pistol from silicone.

Certificate for anchors:

Concrete class from C20/25 to C50/60, cracked, (M 10, M 12, M 16 and M 20), and not cracked

Solid brick brick

Solid brick calcium silicate

Brick, half-full (drilled vertically) in brick

Brick, half-full (drilled vertically) calcium silicate

Lock the cable in normal concrete

Cable lock in lightweight concrete

Concrete autoclaved aerated (cellular)

Certificate for the connection of rebars post-installed in:

Concrete class from C20/25 to C50/60, cracked and non-cracked, for bars with improved bond diameter from 10 to 20 mm.

Also suitable for:

Concrete C12/15

Resin injection-for use with:

Threaded rod FIS A for concrete and masonry

Sleeve threaded internally RG I, for concrete

Sleeve threaded internally FIS AND, for masonry

Blocks, to FIS, HK, stocking and FIS HN and bushes screened the FIS HL, masonry

For fixing of:

Metal construction

Timber construction

Facades

Stairs

Shelves in stainless steel

Machines

Awnings

Canopies

Gates

Console

Grilled

Satellite antennas

Approval:

ETA-17/0429

ETA-17/0435

ETA-17/0899

DoP n. 0160

DoP n. 0161

DoP n. 0162

USE:

T-BOND PRO.1 is an adhesion layer chemical injection bi-component hybrids.

Resin and hardener are in two separate containers and are not mixed or activated until it is extruded through the mixer.

Before performing the installation perform the cleaning of the hole according to the directions.

Extrude the resin from the bottom of the hole, taking care not to leave air bubbles.

Insert the bar manually, causing it to rotate until it reaches the base of the hole.

The resin adheres to the entire surface of the tie bar and to the surface of the hole, sealing it.

The cartridge format silicone in combination with the guns, fischer allows installation fast and simple.

The cartridges are partially used can be reused by simply replacing the mixer.

TECHNICAL DATA

Storage 12 months

Content 300 [ml]

Scale unit 150

Mixers 2 [n.]

Loads P